While downloading and installing ARC is relatively straightforward, I had some minor difficulties arising from my relative unfamiliarity with the finer points of Windows.
#Anthem str power amplifier serial number
I used only the computer version, with the mike and STR both connected directly to the computer's USB inputs.Īfter you've downloaded the ARC software from Anthem's website and opened it, you enter the serial number of the calibrated mike.
#Anthem str power amplifier mac os
There are two versions of the program, one for use with a PC and not compatible with a Mac OS (though Bootcamp on the Mac is claimed to work), the other for use on a mobile device (iOS only). The Silver 10s were positioned about 6' out from one of the short, bay-shaped walls of my room, spaced about 9' apart and just slightly more than that from the main listening seat, and toed in so that their axes crossed just in front of the listener.Īnthem Room Correction comes with a calibrated USB measurement microphone, a mike stand, and various cables. Setting up ARC will take a little longer.Īll listening was done with my Monitor Audio Silver 10 speakers, and without subwoofer(s).
![anthem str power amplifier anthem str power amplifier](https://www.trutone.ca/files/image/attachment/7118/str-power-amp-blk.jpg)
I left most of the controls at their factory default settings, which meant that it took me about five minutes to get the STR up and running. But with its ability to set up different inputs separately, use more than one setup for any input, pass along an analog input unaltered or convert it to digital for processing, and more, the STR is exceptionally flexible. There are also housekeeping controls: Display Brightness, Mute Level, Maximum Volume, and volume level at power-on.īecause I evaluated the STR full range, without a subwoofer, and only with a digital input, my setup was far simpler than the above discussion might imply. This made switching between them, for comparisons, far easier than drilling down into the menu to turn ARC on and off. For example, I set up two separately named configurations for Coax 1, the input I used 99% of the time: one with ARC on, the other with ARC off. And while it also isn't made entirely clear, the same input can be configured in different ways with different names.
![anthem str power amplifier anthem str power amplifier](https://gammadelta.it/wp-content/uploads/2019/07/Anthem_STR_Power_Amplifier_01-1030x687.jpg)
But the manual uses the words profile and configuration (or config) synonymously, which can be confusing. Since I didn't use a sub, I used only a single Profile. There are four different Profiles, into which you can load different speaker setups eg, with and without a subwoofer.